Waring WFP16SCD User Manual download pdf (Page 11)

20 21

Unit stops running during processing

• The unit may have overheated. Refer to Resetting Thermal

Protection section (page 15).

• Turn unit off and unplug.

• Remove bowl attachment.

• Remove food being processed from inside the bowl and discard.

• Allow unit to cool for 30 minutes.

• Reassemble unit, and run rst with the bowl empty, then put

food into the bowl and try again.

Unit jams or vibrates excessively

• Turn unit off and unplug.

• Disassemble the batch bowl/accessories.

• Make sure there is no food in S-blade hub (if applicable).

• Clean food off accessory discs (if applicable).

• Reassemble unit, and run rst with the bowl empty, then put

food into the bowl and try again.

Unit will not come up to full speed

• Bowl is overloaded – remove food being processed and reload

using smaller quantities.

If unit does not operate after you have followed the above

• Check outlet to be sure there is current.

• Check to be sure circuit breaker is on.

• Check to be sure the fuse is not blown if there are fuses on this

circuit.

• Call a local Waring service agency.

If food processor makes grinding noise

• Turn unit off, unplug, disassemble, check bowl and blade to see

if they have been rubbing together.

• If bowl and blade are rubbing, call your authorized Waring

service agency.

JULIENNE DISC OPERATION

Waring Commercial offers a julienne disc as an optional accessory.

Follow the instructions below to operate.

• Prepare all food items to be processed by washing and peeling

as required. Remove pits, stones, and large seeds. Be sure the

food will t into the proper feed chute.

• If a long horizontal cut is desired – for example, squash sticks –

the food must be placed in the feed chute horizontally or on its

side. For nely chopped food results – for example, chopped

celery or nely chopped onions, you must insert the vegetables

vertically or standing up. For a very ne chop of onions, quarter

the onion and gravity-feed it through the chute.

Removing processed food from the batch bowl

1. Turn the machine off and wait for the blade to stop moving

before removing the lid and pusher.

2. If the blade holds the bowl locked when the motor stops,

move the handle of the bowl rapidly back and forth – rst

clockwise, then counterclockwise.

3. If using a disc, remove before tilting the bowl, using a spatula

to scrape off any food sticking to it. If using S-blade, it will

stay locked in the bowl when you tilt to pour. Use spatula

to scrape food out of bowl. NEVER USE FINGERS TO

REMOVE FOOD WHILE BLADE IS IN BOWL.

TROUBLESHOOTING

This section describes potential problems and the correct

solutions for them. Problems that cannot be solved with the

guidelines listed below should be referred to one of the Waring

Authorized Service Centers for assistance. A listing of authorized

service agencies is supplied with each Waring food processor.

Unit does not start when assembled correctly

• Pull the plug and try plugging into another outlet.

• Make sure the bowl is properly positioned on the motor base,

that the bowl cover is attached properly, and that the safety

interlock tab on the cover has properly engaged the safety

interlock switch.

• Press ON button.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 34 35

Comments to this Manuals

No comments

Waring WFP16SCD User Manual Page 11

Comments to this Manuals