Waring WFP16SCD User Manual download pdf (Page 8)

14 15

Large pusher

This pusher is typically used when inserting vegetables

horizontally for longer cuts.

RESETTING THERMAL PROTECTION

The WFP16SCD Food Processor is equipped with an automatic

reset switch to protect the motor from overheating.

If your food processor stops running under heavy use, press the

OFF button and unplug the power cord. Empty the work bowl of

all its contents and discard. Allow approximately 30 minutes for

the motor to cool down.

Reassemble unit, plug the power cord back into the outlet and

run rst with the bowl empty. Put food into the bowl and continue

processing.

If your food processor does not function properly following

this procedure, discontinue use and contact a Certied Waring

Customer Service Center.

USE INSTRUCTIONS FOR S-BLADE

(CUTTER BLADE)

• The sealed S-blade (cutter blade) is designed for chopping,

grinding, puréeing, blending, mixing or kneading.

• Assemble the bowl and blade as instructed in the section titled

“Assembly of Batch Bowl Parts” (page 8).

Chopping and mincing

• To chop or mince in the bowl, ll the bowl up to ¾ full.

• To chop or mince most effectively, use the pulse function. This

allows for better control over consistancy. Continue pulsing until

the desired consistency has been reached.

• If chopped foods are processed continuously, the food could

be processed unevenly, i.e., food on the bottom will be nely

chopped and food on the top will be more coarse.

Chopping meat

Cut meat into 1-inch (2.5 cm) pieces to ensure an even chop.

Process no more than 2.25 lb. of meat. Press the PULSE button

• Always use the PULSE button for pulsing. Never move the

bowl and cover assembly on or off to control pulses. It is less

efcient and could damage the machine.

Turning the machine off with the OFF Button.

• Always switch the food processor off by pressing and releasing

the OFF button. This assures that the power is not supplied to

the motor.

• Always switch the food processor off and wait until rotation

stops before removing the cover.

• While the safety interlock switch will turn the machine off if the

bowl is rotated clockwise or the cover is removed while running,

this should not be the means of turning the machine on or off.

• As a safety precaution, always make sure the machine is off by

pressing the OFF button before pushing down the lid.

FOOD PREPARATION

• Prepare all food items to be processed by washing and peeling

as required. Remove pits, stones, and large seeds.

• Cut vegetables, meats, cheeses, etc. into sizes that will t

into either the small or large feed tube for processing with

accessory discs.

• Preparation for slicing: Produce that is long and cylindrical such

as carrots, cucumbers and celery should be cut at at both

ends. This will provide a consistent slice for all food processed.

FOOD PUSHER SELECTION

The feed tube can be used for adding ingredients while the food

processor is running. However, it is recommended that the food

pushers be left in place whenever possible to prevent splashing

and avoid unwanted additions to the work bowl.

Small pusher

This pusher is typically used when inserting vegetables vertically

for smaller cuts. It should be used when slicing foods such as

carrots, celery, pepperoni, etc. when a consistent, at result is

desired.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 34 35

Comments to this Manuals

No comments

Waring WFP16SCD User Manual Page 8

Comments to this Manuals