Waring PRO JEX450 Troubleshooting Guide download pdf (Page 11)

Step 5

Juice will flow into the juice collector cup and the separat-

ed pulp will accumulate in the pulp container.

Note: The pulp container can be emptied during juicing by

turning the juice extractor to the off position, then carefully

removing the pulp container. You can reserve the pulp for

soups, sauces or cakes. Or, you can discard the pulp.

For your convenience, the juice cup is equipped with a

froth/foam separator. To remove, simply pull up. To insert,

slide down. This part is not dishwasher-safe.

NEVER USE FINGERS TO PUSH FOOD

DOWN THE FEED CHUTE OR TO

CLEAR THE FEED CHUTE.

ALWAYS USE THE FOOD

PUSHER PROVIDED.

Note: Do not allow the pulp container to

overfill as this may prevent correct operation

or damage the unit.

Cleanup tip: For easy cleaning, immediately after each use

wash the Juicerator

removable parts with soap and water

under running water to remove wet sticky pulp. Removable

parts (except the froth/foam separator) can be air dried or

can also be cleaned by placing on top shelf of dishwasher.

Step 6

Replace the pulp container by tilting it slightly, grasping the

pulp container lip, then push lightly until it snaps into place.

Thermal Protector

For your safety and protection, this juice extractor is

equipped with a thermal protector. Should the juice

extractor overheat, the motor will automatically shut off.

To restart, follow these steps:

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

No comments

Waring PRO JEX450 Troubleshooting Guide Page 11