Waring WFP16S User Manual download pdf (Page 6)

10 11

How they work: ON: Press the ON button to start the motor.

OFF: To turn the motor off, press the OFF

button.

To pulse the motor, press the PULSE button

down, then release. The motor will run as

long as you hold the button down; it stops

when you release the button. Try it a few

times.

HOW TO USE

Continuous use

For continuous processing, use the ON button which is located in

the middle.

Pulsing

• For rapid on-off operation, called pulsing, use the PULSE

button located on the right. The motor runs as long as you hold

the button down; it stops when you release the button.

• You control pulsing. You control the duration of each pulse by

the amount of time you hold the button down. You control the

frequency of pulses by the rate at which you press the button.

The interval between pulses must be long enough to allow

everything in the work bowl to fall to the bottom.

• Pulsing gives you precise control over chopping, mincing,

blending and mixing. You can process food to any texture or

consistency you want, from coarse to ne.

• Pulsing is also useful in processing hard foods. Pulse the food

a few times to break up into smaller parts. Then proceed with

continuous use after the pieces are broken up and easier to

process.

• Always use the PULSE button for pulsing. Never move the

bowl and cover assembly on or off to control pulses. It is less

efcient and could damage the machine.

Turning off

Always turn the machine off with the OFF button and wait until

the blade or disc comes to a complete stop before removing

It is recommended that you remove the bowl from the motor

base before you remove the S-blade or whipping disc.

• To remove the blade or disc, keep a slight downward pressure

on the top of the center hub of the blade or disc while removing

the bowl from the motor base. This will form a seal to prevent

food particles from spilling into the center tube of the bowl and

onto the motor base or the work surface. REMOVE ALL FOOD

AND LIQUID BEFORE REMOVING S-BLADE OR WHIPPING

DISC, OR BOWL WILL LEAK. Then remove the S-blade or

whipping disc from the bowl by pulling upward to unlock the

seal. Handle the S-blade or whipping disc with caution; the

blades are extremely sharp.

Disassembly when removing an accessory disc

• Do not remove the work bowl until the accessory disc is

removed.

• To remove an accessory disc, place your ngers on the outer

edge of two opposite sides of the disc and lift. The disc should

remove cleanly. To remove the detachable stem, hold the disc in

one hand with the stem facing away from your hand. Be careful

not to scrape your hand on any sharp edges.

• Remove the work bowl from the unit by rotating clockwise (left)

to disengage the tabs on the bottom of the bowl platform from

the work bowl. When the bowl handle is on the left (about 7

o’clock position), you can gently lift the bowl straight up and

out.

OPERATING THE CONTROLS

• Plug the machine into an electrical outlet. The outlet must be

120V, 60Hz.

• There are three control buttons on the base unit.

The three controls are: ON

OFF

PULSE

1 2 3 4 5 6 7 8 9 10 11 ... 32 33

Comments to this Manuals

No comments

Waring WFP16S User Manual Page 6

Comments to this Manuals

Related products and manuals for Food processors Waring WFP16S